Description: A ready‐to‐use colourless, solvent‐based liquid for sealing paving, blocks and patios and stabilising sand joints. 

Benefits:  Protects against staining of oil. Resistant to chipping and peeling. Hard wearing and durable. Long lasting and weather resistant. Unaffected by UV, water or ice. Enhances colour of weathered and new paving. Gloss finish for enriched colour. Resists weed and grass growth between joints.                                                       

Uses: Once cured leaves the surface with a gloss, clear finish, enhancing the colour of the substrate and providing long lasting protection against oil and water staining. Preparation Surfaces should be free from dirt, oil, grease, dust or any other contaminants, including any jointing sand residue. Organic growth should be removed. Surfaces MUST be dry prior to application. Allow 8 weeks between paver installation and sealing. Ensure jointing sand is dry and contains no moisture (ideally the sand should be applied and compacted just prior to application). Product should also not be applied at temperatures below 5°C or above 30°C. If any other previous stabiliser or sealer has been used this must be removed before application.                                   

Application A two-coat application is recommended in most cases. Apply the first coat to the surface with a brush, roller or squeegee and leave until touch dry (usually 4 hours, can take up to 12 hours dependent on weather). Then apply a second coat to the surface in the same manner and leave to fully cure. Additional coats may be required for exceptionally porous surfaces. This can be determined by a small porosity test to the surface in an inconspicuous area. We suggest an area be subjected to a sprinkling of water via a watering can with rose attachment, if the water beads then a further application is not necessary. However, if the water is absorbed by the patio surface re-application is recommended.