QUICKSCURBBER PAD SET 

QuickScrubber Kit consists of a scrub pad and holder that

allows application of QuickPrime. The QuickScrubber pad is secured to the bottom of the holder.

The bottom-bearing surface of the QuickScrubber holder is flat. When proper pressure is applied, the handle flattens out assuring that proper pressure is maintained.

 

Install a QuickScrubber pad on the bottom of the handle by pressing the pad onto the industrial grade Velcro surface with firm hand pressure. Use back and forth strokes with heavy pressure along the length of the splicing area, until membrane surfaces become dark gray in color with no streaking or puddling.

Bear down on the QuickScrubber pad during application to ensure the total surface is in contact with the priming surface. Each pad will prime about 30.5 m - 61.0 m (100.0’ - 200.0’) by 152.4 mm - 177.8 mm (6.0" - 7.0”) wide area. Change pads routinely. Do not attempt to turn pads over and re-use: discard after 30.5 m - 61.0 m (100.0’ - 200.0’) of priming.

Note: Additional application instructions on the use of QuickPrime Plus and QuickScrubber can be found on the QuickPrime Plus Technical Information Sheet and in Firestone’s PondGard Technical Specifications Manual.